The origin on the K40 is usually the left rear and that is where the home switches are. I made no adjustments, I didn’t touch the program or the work piece. This time the K40 goes to the top right and spells MILA out properly. Without adjusting anything, I hit the start button again. The K40 goes to the bottom right and writes MILA with all the letters on top of one another (See first photo below). I ran the word MILA in the middle of my work space. For example, I wanted to do some test burns for a dog tag I would like to make my new puppy. When I start a job sometimes the machine randomly goes to a completely different location.I set my bed size by measuring it from end to end where the laser stops and I set my origin in the top right as that is where the machine seems to not mirror my work and actually respond with a what you see is what you get on the screen. I am not sure what might be lightburn related or possibly board/laser related so bare with me and my questions if you can. I have been using lightburn and the lightburn 5mp camera but I am having a ton of issues. Hi All, I am new to lasers and bought a used K40 with a cohesion board installed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |